Metrohm IC Net 2.3 Manual de usuario descargar pdf (Pagina 159)

100

101

6.14 753 Suppressor Module

IC Net 2.3

149

First column Time at which program instruction is ap-

plied.

Entry range: 0.0 ... 999.9 min

If no time is entered, the program instruc-

tion is applied together with the last instruc-

tion with time entry.

Second column Program instruction (see below).

Third column Parameter for program instruction (see be-

low).

ENABLED Enable program start (a disabled program

is not started).

<Add> Add new program instruction.

<Delete> Delete selected program instruction.

<Verify> Test the time program (error messages are

displayed if program is wrong).

List of program instructions

The following program instructions can be added to the time pro-

gram on the Program page:

Instruction Parameter entry Meaning

Program RESET, END

Set program flag. The END flag

can be used to end a program,

especially if the program time

should be longer than the chro-

matogram

duration. Additional

steps after this flag are not al-

lowed. The

RESET flag is used to

reset the parameters to the sys-

tem startup values.

Pump on, off Switch on or off the pump drive.

Step Rotate suppressor to the next

position.

Links

The

Links tab of the 753 Suppressor Module is used for Event line

selection.

1 2 ... 154 155 156 157 158 159 160 161 162 163 164 ... 388 389

Comentarios a estos manuales

Sin comentarios

Metrohm IC Net 2.3 Manual de usuario Pagina 159

Comentarios a estos manuales

Relacionado con productos y manuales para Software Metrohm IC Net 2.3