Metrohm 797 VA Computrace Manual de usuario Pagina 272

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 295
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 271
9 Troubleshooting
797 VA Computrace – Software
260
Samples
1. The amount of sample depends on the concentration of the
element to be determined.
2. If the sample matrix is known, a better assessment of the
analysis can be made (organic components?).
3. A digestion must be carried out on contaminated samples and
on samples where contamination is suspected (see Metrohm
Monograph «Sample preparation for techniques in voltam-
metric trace analysis»).
4. A lot of errors are made during sampling and when storing the
sample. Caution and a critical approach are required.
5. The sample should have a good solubility in the electrolyte and
be mixable with it.
Blank values, contamination
The following points should be checked if the results are too
high:
1. Have the dilutions been made correctly?
2. Have contamination risks been excluded?
3. Contamination risks are very high at low concentrations:
measuring vessels should be conditioned with dilute HNO
3
so-
lution.
4. Are the chemicals pure enough?
"Suprapure" grade reagents should be used at low concentra-
tions.
5. Very high concentrations were measured in the previous analy-
sis:
electrodes and measuring vessels must be carefully cleaned and
conditioned (memory effects).
6. Has the standard addition been carried out properly?
Was the volume set correctly on the pipetting unit?
The following points should be checked if the results are too
low:
1. Concentration too high?
HMDE overloaded, use DME/SMDE instead?
2. Buffer not correct?
Make up new one if necessary.
3. Addition ratio too low?
4. Addition ratio too high?
Selection of VA Measurement mode
The following points should be considered by selecting the VA
measurement mode:
Vista de pagina 271
1 2 ... 267 268 269 270 271 272 273 274 275 276 277 ... 294 295

Comentarios a estos manuales

Sin comentarios