Metrohm 856 Conductivity Module Manual de usuario descargar pdf (Pagina 22)

3.3 Connecting MSB devices

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭

￭￭￭￭￭￭￭￭

856 Conductivity Module

Figure 7 Connecting a dosing device

3.3.2 Connecting a stirrer or titration stand

You can use the following instruments:

￭ With built-in magnetic stirrer (stirring "from below"):

– 801 Stirrer

– 803 Ti Stand

￭ Without built-in magnetic stirrer (stirring "from above"):

– 804 Ti Stand with propeller stirrer 802 Stirrer

Connect a stirrer or a titration stand as follows:

Connecting the stirrer or titration stand

￭ Exit the control software.

￭ Connect the connection cable of the magnetic stirrer or of the

titration stand to one of the sockets marked with MSB on the

rear of the control instrument.

￭ 804 Ti Stand only: Connect the propeller stirrer to the stirrer con-

nector (socket with stirrer symbol) of the titration stand.

￭ Start the control software.

Figure 8 Connecting an MSB stirrer

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 45 46

Sin comentarios

Metrohm 856 Conductivity Module Manual de usuario Pagina 22